JT-60SA: assembly begins in Naka
18 Feb 2013
-
Masayasu SATO, JT-60SA Project Team
There has recently been much excitement in Naka concerning the assembly of JT-60SA, the "satellite" facility of 澳门六合彩高手 that will model proposals for optimizing plasma operation and investigate advanced plasma modes that could be tested on 澳门六合彩高手 or used later on DEMO.
On 28 January, tokamak assembly began with the cryostat base, the first major component to be delivered by Europe. This marks a very important step forward for the project, which is part of the Broader Approach Agreement signed between Japan and Euratom, and implemented by Japan Atomic Energy Agency (JAEA) and the European Domestic Agency for 澳门六合彩高手 Fusion for Energy (F4E).
The , which supports the weight of the entire tokamak, has a diameter of 12 metres, a height of 3 metres and weighs 250 tonnes. It consists of a double ring in three sectors, a lower structure in three sectors, and an inner cylinder and is assembled using connecting bolts. The manufacturing of the cryostat base was carried out in Aviles, Spain, by IDESA; final machining and pre-assembly was done by ASTURFEITO under the supervision of CIEMAT.
Anticipation had started to build already in November 2012 with the final of the cryostat base at the manufacturing facility. An accurate dimensional tolerance check was performed with a 3D portable laser tracker, and results proved to be satisfactory with low error under the limits.
The cryostat base was collected from the factory on 12 November and to the port. After loading the cryostat base on board the IYO, the ship set sail on 22 November and took on further cargo at other European ports before heading across the Atlantic and Pacific oceans via the Panama Canal. After the 18,000-km-long sea voyage, the cryostat base finally arrived at Hitachi port in Japan on 16 January 2013.
By 8 November, the manufacture was completed and all parts of the cryostat base were packed for . Due to their large size (maximum width 6.5 m), the pieces were difficult to transport, especially by road, but fortunately the factories where the cryostat base was fabricated and machined were close to one another as well as to the port.
The cryostat base was collected from the factory on 12 November and to the port. After loading the cryostat base on board the IYO, the ship set sail on 22 November and took on further cargo at other European ports before heading across the Atlantic and Pacific oceans via the Panama Canal. After the 18,000-km-long sea voyage, the cryostat base finally arrived at Hitachi port in Japan on 16 January 2013.
The transport from the port to the Naka Fusion Institute was conducted by JAEA in seven stages during the week starting 19 January. Transport was carried out before dawn on closed roads All seven pieces of the cryostat base were to the assembly hall at the Naka Fusion Institute by 26 January.
Tokamak assembly began two days later. The start was open to the press and reporters from ten media organizations were able to witness the first assembly work. This event was widely reported to the public through newspapers, web, and TV, including the national news.
This timely start to the assembly of the JT-60SA Tokamak is the beginning of a six-year assembly and commissioning period which will enable the first plasma to be achieved in March 2019, ready for this project's role to support and complement 澳门六合彩高手.